Bryant 463AAC008BA Air Conditioner "compressor reset button wiring" Questions

...compressor will not come on. Siding people unhooked and rehooked. Is there a reset button? We already checked the breaker and it's o.k. Any suggestions? Thank you They may have cut the low voltage ...

compressor but it won't turn on. could relay be problem? Is there a reset button (where) on these units and if so try that before replacing relay? Relay could be problem. See if thermostat makes relay

...compressor on. If it is not, do a reset of the CCC. For a five button system, turn the tstat off and hold down the Mode and Zone buttons simultaneously. While holding them down, turn the CCC on and ...

...compressor that is done. Could you help me? see this causes and fix it. God bless youMotor Trouble Cause Diagnostic Procedure Repair Procedure Electrical Power is Off Check that all service switches ...

...compressor turns off. Then I press reset button and it's works again for aboout 5min and no cool air. I hope someone can help me solve my problem. Thank Ken i just opened the back of the unit and ...

compressor reset button. Hi , you may use amphere meter to detect whats goin on to the compressor and component. Clamp one compressor wire if register exceed the laber amphere of motor motor are stuck

...reset. Where the button is depends on who made the switch. If its a red plastic body type the button will be on 1 end. If its metallic and rectangular it button will be about 1/4 inch long and ...

reset button. Green light is illuminated but it acts as though it has no power. Any thoughts? When a sett is kep unused for sometime the possibility of faults can vary as when it is in regular use.The

...compressor kicks in but as soon as we release the reset button, it goes off. Is there another reset button/switch or is this possibly related to the indoor portion of the system? Hi, Sounds like the ...

...bad? thank you. yes, I would try the capacitor first and also look at the wires that connect to the compressor. Look for a reset button on the front of the unit first as it may just needs to be ...