furnace and every time i lite the pilot the heat starts and runs good for 2 hours and then both heat strips and pilot lites goes out again I'm a little confused by your terminology. You are saying you
Question about Carrier Heating & Cooling
...furnace under normal conditions: Draft inducer motor starts. Runs for 2 min, then there is a loud relay click (I believe that this is the gas valve turning on). I then hear the spark igniter go and a ...
...little later. I told her to shut it off, and I'd look at it when I got home. With the two covers off the furnace, I returned power to it, then pressed the safety switch so I could see everything ...
...furnace that accesses the valve, burner, etc. Find your pilot assembly, this consists of the hot surface ignitor, (which glows bright when lighting) and the little rod next to it about around as a ...
...little rap with the handle of a screwdriver or similar a couple of times, and see if fan stops running. While your there as well, pull the wiring connector off the ignition board, and put back on a ...
Question about Heating & Cooling
...Furnace started up for a few seconds the shut down with no indicator light. I went up and switched disconnect off and on, then checked all connections and fuse on circuit board, all good. Closed up ...
...furnace. filters is clean. it will start to light then stop . Several times of recyling power normally brings the furnance up. Though the failure code has always been 31, there are several different ...
furnace itself) or something kicks on, the burners ignite a few seconds later, then the blower starts. It's at this time the flame goes out and the blower is just sending cold air throughout the house
...furnace is at a rental. was there to experience the problem, turn up tstat, clicker came on to light pilot. pilot lights, burners light, then the blower seemed like it came on at a slow speed, seemed ...
...furnace has run dirty and sooty - there's probably black soot covering the sensor, blocking the light of the flame. Remove, wipe the lens, and reassemble. Try for ignition again. Keep in mind, after ...
62 questions posted
Usually answered in minutes!
24 Questions
3 Questions