Danby DCD5505W Electric Dryer "screws power cable" Questions

...power cord for your dryer depends on the available receptacle. For a 4 wire cord connect the two outside wires in the cable to the two outside screw terminals , connect the center white wire to the ...

...power feeder block - item 52 in the diagram you can see at ...

power cord: ? Remove the screws from the cover of the junction box located at the top rear of the dryer. ? Loosen/remove the two screws on the strain relief clamp and remove from 4-wire supply cord. ?

power cable and back cover completely. Note last two screws holding back cover are under the top cover which is held on with two screws at the rear. Remove the screws then pull top cover back and then

power cord with plug on it, remove back of dryer, undo screws on old cable one at a time and install new wire: example---remove a red wire from old cable and then put on the new red wire , move to the

...power cable and back cover completely. the last two screws hoding back cover are under the top cover which is held on with two screws at the rear. Remove the screws then pull top cover back and then ...

...power cable and back cover completely. two screws holding back cover are under the top cover which is held on with two screws at the rear. Remove the screws then pull top cover back and then lift it ...

screws. Open door pull out and up on front input display bezel carefully. Same process as before remove all cables and reinstall them back in there original location. Then reassemble in reverse order.

...power cable and back cover completely. two screws holding back cover are under the top cover which is held on with two screws at the rear. Remove the screws then pull top cover back and then lift it ...

...power cable and back cover completely. two screws holding back cover are under the top cover which is held on with two screws at the rear. Remove the screws then pull top cover back and then lift it ...