Danby DCD5505W Electric Dryer "relay" Questions

Ad

Question about Kenmore Dryers

1 Answer

replace part 3405281 The problem is with the two relays, heater relay and the motor relay, both of which are identical relays. If the motor relay is broken, you have the switch problem. If the heater ...

Ad

...220 at the outlet. All tested good. What am i over looking? What you have not tested is the heater relay located behind the console. Disconnect power to the washer then remove the screws attaching ...

Ad

the panel lights are on but it wont turn on and clicks and says sensing sounds like one of the relay on the main board is bad. some models have heater relay and motor relay off the board, you might ...

...along with the fan wheel in a plastic housing. Could remove cover but didn't see motor. Could a relay switch be bad at the control panel? I ran the manufacturer's test and everything signaled ...

Question about Kenmore Dryers

1 Answer

Wont stay on Will start but wont stay on Check under the console for a motor relay. If a motor relay is present replace it. On some models the relay is part of the start switch. The relay will be a ...

...down so I'm not sure what the problem is. The start button starts the motor heater and energizes a relay that latches closed to keep the motor and heater running untill the timer switch or door ...

Question about Samsung Dryers

1 Answer

shows hE code, does not cool down possible Heater Relay failure Heater relay stuck open or closed; Wiring defective Check for short circuit across heater relay(s) (RL5, RL6, RL7) or L1 applied to ...

63942 Kenmore Dryer will not run unless start switch is held on. Swapping relays did not solve the problem. Shorting blue wires on motor relay together allowed the start button to be released. Do you ...

Question about Kenmore Dryers

1 Answer

it stays running. Help please. with power disconnected follow the wires from the start button, to a relay, check the wires (both ends) of all leads to the relay and reconnect any that have fallen off.

Question about Whirlpool Dryers

1 Answer

...see a burnt resistor on the board. If it is not an evenheat dryer, than youmost likely have a bad relay inside the control panel. There are 2 relays. One is the motor relay and one is the heat

Not finding what you are looking for?
Danby DCD5505W Electric Dryer Logo

117 questions posted

Ask a Question

Usually answered in minutes!

Top Danby Dryers Experts

Brad Brown

Level 3 Expert

19187 Answers

Jorgie  the...
Jorgie the...

Level 3 Expert

5639 Answers

Amy Smith
Amy Smith

Level 2 Expert

81 Answers

Are you a Danby Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...