Question about Black & Decker Coffee Makers & Espresso Machines
...thermal fuse should be located near the coil. Usually just below the plate, but that all depends on the model. I hope this helps! :) They are inline with the thermal cutoff switch, which is attached ...
Question about Black & Decker Coffee Makers & Espresso Machines
black & decker spacemaker coffee maker thermal 2 thermal cut-off fuses need replacing. one is 8240, other is 8216. what order do the go in relation to the flow of current. It doesn't matter.
Question about Black & Decker Coffee Makers & Espresso Machines
...thermal fuse temperature Anybody know what temperature of thermal fuse should be in this unit? When I took it apart, it had been previously repaired and there were two in series, with different ...
Question about Black & Decker Coffee Makers & Espresso Machines
...thermal cutoff fuse located on the bottom heating plate. It is usually in series with one of the leads to the actual heater. This should read "short" with an ohm meter. If it is "open" it needs ...
Coffee does not brew Red light indicates machine is on but does not brew. the heater eleiment is bad or the thermal fuses conncting the elements are blown
...for a repair shop in your area. I suspect a thermal fuse has blown in your unit. Only an experienced repair tech can replace it. Sometimes, the cost of the repair is more than a replacement
Question about Black & Decker Coffee Makers & Espresso Machines
...clock is also not on the thermal fuse has blown. be careful after replacing it because the reason it blew is probably because the unit overheated which means the thermal switch failed (stayed
Question about Black & Decker Coffee Makers & Espresso Machines
...thermal fuse located near the heating element and in series with the element itself. This device is bullet-shaped with one lead connected to the case, the other insulated from it. If there was ...
...thermal fuse. They are in line with the power to interupt the circuit if the unit gets too hot but over time they will blow out from all the heating cycles. The fuse looks like a small metal cylinder ...
Question about Coffee Makers & Espresso Machines
...thermal fuse (looks like a 22 shell with a wire from each end) that is supposed to melt it's internal link when the near-by temperature is too high. A replacement is to be 'crimp connected' as ...
37 questions posted
Usually answered in minutes!
208 Questions
72 Questions
45 Questions