Black & Decker GT300 Coffee Maker "fix back" Questions

...flange of 2mm. simply pull the back cover off with fingers hooked on each side, the cover will flex. Otherwise cut the bottom flange with a knive and use some duct tape to fix it later at that ...

...fix was to just finish the cleaning cycle without the tray in and at the end the flap was back in place and we could fit the tray in again. I just used my air compressor inside and that was it fixed

...in for repair. Cost $235.00. Nothing I did would fix the issue. They said there was a major blockage. They cleaned it and sent it back. They also fixed my issue with water leaking from the

...to fix it? How can I fix or do I need to ship it back to Jura? Try applying hot water around the dish to expand and unstuck while gently but firmly pull the tray. It went in so must come

...would be and see if it starts blinking slow and heats. If yes Then replace tank with new float. Fixed! If not. 2. Unplug and then take the back cover off and make sure the electronic magnet

...back on? Check out a couple of these sites.. ...

...suppose to. I did not get all the parts with mine so if anyone tries this please post the outcome. Remember to unplug the machine before you open the back. I will post the real fix if I figure it

...back into the reservoir. Very little water, if any, is making its way to the warming chamber. How can I fix this? i have a water problem but mine is .. when i turn the machine on it just starts ...

back if you don't fix the fault, in my case always the grinder. 1) DISCONNECT THE MAINS. 2) Take the drip tray out, open the plastic side panel (door) on the R/H side of the machine (the grinder unit)

...would be and see if it starts blinking slow and heats. If yes Then replace tank with new float. Fixed! If not. 2. Unplug and then take the back cover off and make sure the electronic magnet