KitchenAid Architect KTLA19KRSS Stainless Steel Top Freezer Refrigerator "refrigerator hinge seal" Questions

Either pop rivet some new metal plate to replace the rusted area and use existing hinge try get replacement door from used refrigerator or refrigerator recycle place. buy new/used fridge from kijiji :

...seal and in freezer. Door is out of alignment you will have to adjust hinges Good luck Tom depending on where the gaps are your hinges are warped. losen up the hings bolts and adjust hinge then hold ...

...hinge pin should hold your refrigerator door in place.. Uncover the door by removing the screws.Take the door off and pack bottom hinge with washers and make sure hinge brackets on cabinet are tight. ...

...refrigerator door when it won't close, seal, or hold a seal. 1) Clean the Gasket. ... 2) Reattach the Gasket. ... 3) Replace the Seal. ... 4) Balance the Feet. ... 5) Tighten the Hinges. ... 6) Clear ...

...Refrigerator-Door-Seal Two reasons are possible: 1. check if the door has hung on the hinges due to excessive weight or pressure on the hinges as this will alter the alignment resulting in improper ...

refrigerator with a pull out/tilt open bottom freezer. The freezer does not make a seal at the top of the freezer door. It doesn't seem to be a faulty seal, but rather the hinges do not close the door

...refrigerator on 3/8/08. The hinged seal on the left door has broken so that it does not fold inward when the left door is openED or seal automatically when both doors are closed. The hinged seal has ...

...that the alignment was not done properrly with the hinge settings. SO first of all release the hinge sccrews and adjust the seal part to coincide then tighten once by one with minor

...refrigerator and turns to create a seal for the 2 side-by-side doors. The hinge mechanism is held onto the door at the top of the door by a small tab that attaches to the door. The hinge has come off ...

I have a GE side by side. The freezer door will not stay sealed or closed anymore. I have to tape it shut. What can I do? make sure unit is level side to side and front to back if still problem check ...