GE Profile Stainless Bottom-Freezer Refrigerator with Internal Dispenser 22.2 Cu. Ft. - PFS22SIS "stop sliding floor" Questions

How to stop fridge from sliding forward when opening Do the feet not touch the floor? Under the front the two feet need unscrewing so they touch the floor and stabilise the fridge.

...(before sliding the floor out) but it won't seem to budge and I don't want to break it. Any suggestions? Buy a new fan motor . I did on my freezer and it was a easy job and it still works after

how can i roll the refrigerator out to vacumm the coils? open the freezer and when the drawer stops you can pull from the door and it should roll . make sure that a foor is not set in front to prevent

floor below freezer side of Maytag side by side refrigerator. Noticed some ice on very bottom of freezer compartment, should I remove sliding basket and clear it away , possible drain stopped up?? Yes

...floor and reaching around the drawers. I usually end up leaving the ice there, but it really bothers me that it does this! The adjusta cube ice maker has an on/off switch. To stop the ice from ...

all moisture on the metal rails and inside the freezer. Pull freezer door all the way out unitll it stops serveral times. This may realign the freezer door. If not the door slide rails,Track or Roller

...is leaking water on the floor. There is ice build up on the back of the freezer compartment. Water stopped leaking when the filter was taken out. I cleaned all the ice out of the freezer and within ...

... Found out that the ice maker was leaking and the water was in the bottom an it frozen and that was stopping the door to open. August 2013, Amana Freezer Drawer is stuck closed and will budge. ...

stop moisture in the air freezing and building up. A breakdown in the wall insulation. This causes condensation on the outside of the cabinet anywhere on the appliance. There is no way to fix this. Or

...with an ice maker. HELP! I cannot get the freezer floor out to check to see if the drain tube is stopped up. It is screwed in with screws without a head to that I cannot find a bit for. HELP