President Lincon 10m When keying the mike shows TX on display but no power out back or RF meter reading your final is most likely shot.
Question about Radio Shack Radio Communications
...power, but when I talk into the mic there is nothing there. I can ocassially here someone talk but not to offten? could this be my wipe is to short? At this point I would say that the finals are
Shot This is a weird one. Don't know exactly where to start but here is some ideas. Power filter to the power input, may be run power w/gnd from the battery, try a different antenna, run a ground wire
...the battery is shot. As you indicated the charge light shows good but the minute you draw or try to draw current ( power ) by activating the radio the battery does not have enough life left in
...power output reading and no reply's to calls !! is my radio shot or is there a component I can change ?? hi yes you will need to replace the pa transistor located at the back of the radio under the ...
...unit? If you did you might have noticed the needle go past the 1.2 mark when you were adjusting the antenna or the unit itself. In any event I think that the RF power Amp is shot. Thank ...
power output reading and no reply's to calls !! is my radio shot or is there a component I can change ?? it sounds like u fried your final.. Its only your driver/buffer transistor that's working right
...power side is out. You said it puts out just 2 watts and that is what it would put out on low side. Do you especially break-up after it warms up a little. If it works better cold and when it warms up ...
rewiring my dynascan model 21 cobra cb power wires are shot how do I rewire look at where they were connected and solder new wire in.
...power supply has went bad or the finals in the radio is shot you can send the radio to tandy corp for repair or a good electronics repair center ...
16 questions posted
Usually answered in minutes!
980 Questions
274 Questions
141 Questions
137 Questions
112 Questions