stereo turned up pretty loud and one of the speaker wires came out of the terminal and i think touched the outside of the amp. now when i turn the amp on even without the speakers hooked to it it goes
...stereo mode. If you are running the amplifier in BRIDGE mode then the amplifier is stable only @ 4OHM. So if you are running a sub woofer and it requires a 2 Ohm mono load then the amplifier has ...
...stereo or bridged mono output Tri-way capable (Tri-Way crossover required) 100 watts x 2 at 2 ohms 200 watts x 1 in bridged mode requires 10-gauge power and ground leads ? wiring and hardware not ...
Question about Infinity Car Audio & Video
...bridge mono or operate the amp in stereo mode) if you are running say a 1ohm load on a 2ohm stable amp it will keep going into protect or even pop your fuses do you know what your subs are wired
...mode. Make sure you go by the specs on that specific amp. Usually most amps don't go under 2 ohms stereo and 4 ohms mono. A lot of people start to experiment and notice if they hook-up a certain way, ...
...the characteristic impedance of the mode you were running in (stereo/mono) then I would check if the warranty is ok. If no warranty pop the cover off and give it a quick look for any blown
...mode this kept happening to me. I ended up just running two subs and for some reason the fuse stopped blowing. i think there is something wrong with these amps. Try connecting this sub in stereo ...
...stereo mode then you can hook up 4 - 4 Ohm speakers ( 2 to each R & L) this will present a 2 Ohm load on each output, but you can't have a 2 ohm load on that amp bridged with it gong into protect ...
238 questions posted
Usually answered in minutes!
156 Questions
152 Questions
73 Questions
53 Questions
60 Questions