Sony Xplod XM-554ZR Car Audio Amplifier "ohm run 8 speakers" Questions

...ohm each so i run parallel to make it 4 omh bridge them to get 1200w rms to make it go way!! way louder ok then my mono block my amp is a atomic 30001dmy subs are 2 15" fi,btl i love my sq on the ...

...run those 2 subs in parallel to the amplifier giving it a 4 Ohm load. So, your will have two sets of wires from your amp 1 for each speaker. Then you will take a short piece of wire that will connect ...

ohm load. Hi, To get 2 ohms you don't have to do anything with the amp. Simply use 2 ohms speakers for each of your output. From your other post, I gather that you have bridged it to 2 X 500 (from the

ohm speakers wired in series is 8 ohms and then is dropped back down to 4 ohms when you bridge it. 2 4 ohm speakers wired in parallel is 2 ohms then dropped down to 1 ohm when bridged (most amplifiers

...4 ohm speakers wired in parallel = 2 ohm whilst Two 4 ohm speakers wired in series = 8 ohms Car amps are rated at 4 ohms and failure to match speakers to this can cause amps to run very hot or

...run dual ap1200 amps and i tried it single and it does the same thing. its not the car wiring i think it may be something with the amp but im not sure. check for earth The first diagnostic move is to ...

run parallel. When you connect speakers in parallel, the total impedance (ohms) is calculated by dividing the impedance of one speaker by the number of speakers, assuming they're all the same. When in

...ohm total load on your amp. This is BAD for your amp. Your option is to run the subwoofers in series. To run the speakers in series is simple. The + from one speaker and the - from the other will be ...

...8 Ohm (Stereo), 4~8 Ohm (Bridged) Continuous Power (4 ohm) 125W x 2 Continuous Power (2 ohm) 190W x 2 Continuous Power Bridged (4 ohm) 380W x 1 Frequency Response 10Hz ~ 50kHz Total Harmonic ...

...ohm stable when ran using two channels. so either run the speakers at 8 ohms each parallel or just hook one speaker to eack channel. if you do not know what i am talking about then just email me at ...