...and the tub is always filled with water after the cycle is done, I suspect that the drain hose is plugged because I hear the water rushing through the jets during the wash cycle More likely: the ...
...either. (Dishwasher is pulled out of cabinet space to see all around). Thanks in advance Check for plugged ...
i have an LE code how can i reset Try unplugging the unit for a few minutes. Then plug back in. If not try the Power button. I have an SE code (drainage problem) and my machine stops running ...
...tub The heater is on after a cycle to sterilize and dry the dishes. This is normal. Are you using a sheeting agent such aas "Jet Dry" in the dispenser (it is usually filled by a plug on the door).? ...
...this helps. Good luck! Sounds like the filter screen at the bottom under the lower spray arm is plugged. Tear down the entire mechanism under the spray arm until you get to the screen (make note ...
...of detergent being used.Also there is a probability that the drain inside the machine could be plugged. Also check the latch and the rubber gasket/seal around the door. Also it could be the
...rotating; check your user's guide for proper loading methods. the holes in the spray arm can be plugged from food particles or other debris, like coffee grounds; remove the spray arm and clean
...tub and looks like a small tube with a cap on it. You should be able to move the cap up and down easily. I had the same problem, all you have to do is open the small rubber plug located behind the ...
...jsrock to check my dishwasher door. I found that the vent area was full of old food debris. 100% plugged! So I cleaned it out and presto changeo !! no more leak.
...advice would greatly appreciated. thanks, chris. Hi, Make sure the jets in the spray arm ore not plugged at all. Check the black bellows on top the lower spray arm and see if it has a split in it. ...
284 questions posted
Usually answered in minutes!
480 Questions
151 Questions
124 Questions
109 Questions
91 Questions