Kenmore 3.2 cu. ft. Plus Top Load Washer "washer spin resistance drum" Questions

...spin My maytag washer will not start or spin. THe moter tryes to turn but then the machine kicks off HI, try to physically spin the drum.there should be some slight resistance but not a lot. if the ...

washer goes into the spin cycle is sounds like a walnut is trapped between the drum and the water tight enclosure. No noise when spinning the drum by hand, no resistance, no grinding, everything seems

...washer the drum does not spin freely (resistance, stops after less than a revolution), and still has the squeak. Drum has a little movement front to back, not up when I push up in the middle of the ...

...washer ...checked even with ONLY one item wash , similar noise on SPIN cycle ???? What could be loose/ and rattle on SPIN cycle ???? Thks Rgds YVes Remove drum drive belt, and spin drum by hand, if ...

...pops the breaker Before it started popping the breaker, it squilled during the spin cycle. Sounds like u need to change belt. Also check to see if the drum spins freely. If resistance on drum see

...may be another problem The drum should spin freely with the belt off, there should be no resistance, if there is, then it could be main bearing problem, or somethig stuck between inner and outer

washer machine is not rotating. The belt is working, the motor seems to be working, not sure what the next step should be. Fisrt, see if you can rotate it by hand, BOTH directions. It should have some

spin The washer will not spin when in spin cycle. I have removed the cover at the back, the belt is in place,& when I spin the drum I can feel the desired amount of resistance. The motor goes to start

resistance in both directions, will not spin freely, but turn easy by hand. Do the same with motor. IF the drum and pump moves in both directions, I suspect about the motor. If the

...Washer RAX4232KQ0 that isn't spinning clothes completely dry. I replaced the block a week ago thinking that was the problem and it didn't fix the problem. Now I'm guessing the problem might possibly ...