would bet you have an obstruction in your drain pump. The
check the pump, follow these steps: Unplug the washer while servicing inside and then pull off. If the panel becomes stuck, a slight
tap on either side will dislodge it. Locate the drain pump. It
more...
get the bearing bolt out due to it having a special tapered Alan key socket to get it off. Could try grinding down bit of kit. Thanks anyway for your help. Jon Hi Richie, Checked springs, ok but dampers may have some slack. How much slack
more...
minutes. Does the problem return? While you have the top open,
check all of your connections going to your CCU. Are any loose? (round cylinder 2 1/2 - 3" wide). Give it a firm
tap with something insulated (the handle of your screw driver for instance).
more...
opening our washer (same model) I found a manual for techs taped inside. it gives instruction on how to get the error vise grips worked the best over all. I will be checking pocks more diligently from now on! How does all that
more...
opening our washer (same model) I found a manual for techs taped inside. it gives instruction on how to get the error vise grips worked the best over all. I will be checking pocks more diligently from now on! How does all that
more...
Slacken this bolt a turn or two, DO not remove
completely. Gently
tap the bolt with a soft faced hammer or drift, this
will assist commenced.
8) Rebuild is a reversal of the above, at every step
double
check electrical and hose connections and before you refit the
cabinet front.
Hope
more...
Sponsored Links