Kenmore Elite HE4 Electric Dryer "sump pump" Questions

...in condenser tray. Is there heat? Could be running cold if the elements have burnt out. If there is heat then check the pump and float switch that pumps the water from the sump into the condenser ...

...sump pump failure during electrical outtage (Super Storm Sandy). Appliances in water for 48 hours, both unplugged and gas shut off to dryer. What damage can I expect? 6" of water in basement due ...

...dryer? i emptied tank drawer regularly, but have noticed that there is no water in tank after several uses. The pump sits in a sump behind the condensor if it is not blocked , then the pump is ...

...and the reset switch and found no live feed, I have checked the sump pump and switch are working and all wire connections seem to be intact ...

...like it slows down though. Does the washer drain the water quickly?? Are there any error codes?? Usually the drain pump sump is clogged and not draining, thereby not letting the unit advance to

...sump hose, this is located under the machine, mormally a black hose from the tank to the drain pump, remove from the tank end and look in there, Finally it could be a blockage at the end of the waste ...

...sump there is the float. To extract it rotate the float 90° clockwise as shown. Lift it up, rotate it towards outside and extract it. While reassembling the pump, the float and the tank microswitch, ...

pump grinding THE WATER PUMP HAS SOME PART WHERE IT GRINDS BECAUSE OF THE GARBAGE THE COMES WITH THE SUMP - -  IT HAS TO BE REPLACE MOST LIKE IT...

...pump is getting weak and needs to be replaced rinse agent dispencer may be empty, useing gel or generic soap my cause this use cascade powder it's proven. check how mutch water is in the sump durring ...

...The sump (where the pump sits) is probably full of gunk, you need to take the side off( rh side on older models, lh on newer models) pump sits bottom rear of dryer and has a plastic cover over ...