Question about Dell OptiPlex Computers & Internet
...at me at start up w/o complete start up. Screen Black. As if something is loose? Battery in Motherboard? Did something short out? POST Beep Codes: OptiPlex GXi If the monitor cannot display error ...
chipset heat sink not detected The chip set heat sink is not properly installed on the system board. Ensure that chip set heat sink is properly installed on the system board. To locate the ...
dell motherboard does not come at all when i connect working power supply to my motherboard n switch it power does not come at all If the power doesn't come on at all, or the system powers up but ...
Question about Dell OptiPlex Computers & Internet
...very well • CD drive works But there is no display • I change all RAMs (internal RAM inside the keyboard) • I change all drives (HDD & ODD) Any one help thank you! Here are the beep codes for
my dell optiplex board will not start If your board is not starting then you clean the board with a solution called IP.Or clean it with a blower and then fix it. If you are not satisfied then you need
Question about Dell OptiPlex Computers & Internet
How do you remove the Motherboard from the Dell SX280? simple it slides out it has a green lever in front off the motherboard and you pull it up on some tipes of dell it's a screw to remove that first
...fine. What could this be This sounds like it may be a problem with your video card. Is this on-board video or an add-on card? If it's on-board try adding another card to it (be sure to disable
...behavior (turn on power, fan runs at full speed, no boot), and both needed replacement system boards. (These were a different model, but the symptoms are typical of a dead system board.) I got ...
Question about Dell OptiPlex Computers & Internet
...boot and shut down power light blinks on and off can you help. jimmy Does this Computer have an on board Video card and you installed another card as and upgrade? If so try to get in to the BIOS and ...
Question about Dell OptiPlex Computers & Internet
...are to go back to XP, or see if your computer has a spare PCI slot, if so then buy a PCI VGA board that is Vista supported. When you open your case and install the board, bootup and Vista will ...
434 questions posted
Usually answered in minutes!
848 Questions
511 Questions
428 Questions
349 Questions
179 Questions
