Honeywell Programmable Thermostat Heater "power going ac unit" Questions

...power cuts on and off AC is running for a couple of minutes, LCD panel on the thermostat goes blank, AC unit runs for a couple more minutes then turns off. A few minutes later, the thermostat comes ...

...going to work on the unit yourself make sure all power is shut off. There should be a shutoff switch on the outside wall near the compressor. I?d also shut the breakers off. page 26 27 of the users ...

...power. the older chronotherms were system (24volt ac) powered the new hardware/box store units are battery powered. Either way display should not be blank with fresh batteries. to get heat on remove ...

...power had gone out (sometime), no AC in house and no display on the thermostat. I removed the unit as others had suggested, and flipped the E/F switch. Sorry, didn't work for me. What are the E/F ...

...AC Kicked on. Online, I have learned that on the old White Rogers these wire are: Y=Cooling System G=Fan Relay W=Heating System RC/RH=24v Hot So I tried a couple of other combos and no luck, I just ...

...power! Red means DANGER... CAUTION. (Klein NCVT... mine!)... NCVT = NON-CONTACT Voltage Tester Shut off the house main... if you must. I'm pretty sure it will take less time to rest all those clocks ...

going to R. Q: Where do we put red wire on the new thermostat into R terminal or RC terminal & do we leave the bridge in tact? yes u leave the bridge intact and just put ur red wire to r or rc and

going bad though and replaced it with a new Honeywell Programmable thermostat. All the wires are in place and match up. If I turn the fan on it runs fine, I just cant get the furnace to blow warm air.