Question about HP OfficeJet Office Equipment & Supplies
...the top of the hinge. Remove the broken top half of the hinge and lower the cover back down. Until you find a replacement hinge, you can put a piece of heavy duty tape on the back where the hinge
Question about HP OfficeJet Office Equipment & Supplies
...the top of the hinge. Remove the broken top half of the hinge and lower the cover back down. Until you find a replacement hinge, you can put a piece of heavy duty tape on the back where the hinge
...top cover and remove any debris. 4. If you have not found the jam and have Tray 2 installed, pull out the tray and remove the jammed media, if possible. If not, do the following: a. Ensure the device ...
...Remove the top plastic cover on scanning assy by inserting a small flat blade on the left and right (just behing the lights) and release tabs. Lift front upward till rear tabs are free. - Remove the ...
Question about HP OfficeJet Office Equipment & Supplies
...top cover * Remove the Catridges from the printer * Then just re-install the Catridges * Then just close the unit lid or top cover * After closing, cycle the power of the device by turning of the ...
Question about HP OfficeJet Office Equipment & Supplies
top of the hinge. Remove the broken top half of the hinge and lower the cover back down. Until you find a replacement hinge, you can put a piece of heavy duty tape on the back where the hinge was. Hi,
Question about HP OfficeJet Office Equipment & Supplies
...top cover If the carriage does not move to the left automatically, press and hold the Resume button ( ) for three seconds. Wait for the carriage to stop moving. Remove the cardboard cover from the ...
back cover, unplug the scanner cables, remove the scanner and top cover and then the right side cover. The battery is on the circuit board on the inside side, so you have to remove the board to see it
...top cover and remove any debris. 4. If you have not found the jam and have Tray 2 installed, pull out the tray and remove the jammed media, if possible. If not, do the following: a. Ensure the device ...
...top of the 6110 is attached to the bottom with 4 latches. I remove that, turn it around and clean the glass. Note: The cables between 6110-bottom and control panel/feeding unit are long enough to set ...
3,272 questions posted
Usually answered in minutes!
1,584 Questions
1,223 Questions
991 Questions
857 Questions
782 Questions