Intertherm P3RA-024K Air Conditioner "burnt smell ac unit" Questions

...on the side of the unit and check them for ok. If any one of them looks burnt, replace it. These two places are usually the only place that you will get a burned plastic smell. Hope this helps, ...

...burnt smell comig through the vents. It seems to cool, but the blower is not as strong as earlier in the day. I als see that the compressor issweating. What could be the problem, and what's the ...

...AC worked fine with the burnt overload switch removed. It has been runnning 2 days now with no problems. I however did replace the capacitor with a new one. You can use either an oval or round ...

...Checked control box and all connections seem fine and NO burnt smell. Any ideas? It could have the sensor wire not plugged all the way or maybe a broke sensor wire from console to condenser ...

...ac/htpump does not work . Did I Ruin the unit or can it be repaired? Also the 12v capacitor is out It's hard to say. You should probably start by checking your transformer. I don't think line voltage ...

...burnt rubber smell up on the roof and then it just shuts off. it will then try to come back on in a few minutes and do it all over agian. any ideas?? how much aM i lookin at to fix this? I appreciate ...

...smell burnt plastic smell. Replaced, control box, that got fan only working. Tried another thermostat , everything worked as it should. Turns out the lightning, or power surge, or whatever, shorted ...

burnt smell so I stopped it. When I checked the motor it looked fine but it would not start. I helped it by turning the fan and it worked. Could it be the condenser going bad? and if so, what would be

...smell,the coils were red hot and cycling on and off with the fan off and temp reached,still heating,only shut off seconds when thermocouple?( safety pops ),then comes back on heating every 20-30 ...

AC unit. There is a silver box with the electronics inside. Remove this box and remove the cover. Visually inspect the connections where the 120VAC connects. If that looks ok, then check the relays on