Intertherm P3RA-060K Air Conditioner "put fuses" Questions

...fuse do I buy to replace it? Are the Line 1 and Line 2 fuses supposed to be the same? the fuses should be time delay 30 amp both fuses should be the same check the pcb board and then put fuse ...

...keep blowing transformer what you need to do is isolate the loads that are on the transformer and put a amp meter on the transformer and read the amps while you put the loads on one at a time. the ...

...fuses. sometimes they put a fuse link inline with ac input cord and heat shrink it...get your ohm meter out and test all fuses you find for continuity. replace with exact if new one blows you have a ...

...put in a new thermastat and now the ac wont work. Is there a fuse? R--redwire-power y-yellow wire -cool g-green---fan w-white -heat. If you turned it off &back on too fast, then you probably did blow ...

...put a probe on either side of the fuses. You should have 0 volts if the fuse is good. You will have supply voltage if the fuse is burnt. If you check without power pull the fuse and use audible ...

intertherm thermostat wiring problem My husband tried to put in a new digital thermostat but it turned out to be not compatible now we are trying to put the old one on and it doesn't now seem to work ...

...any wording on it like power or service Some brands alow the fuse holder to be put in upside down for the service man to work on the unit If not have some one check the fuses to see if thy mite be ...

...fuses at my service disconnect. Just started and it's been very hot in N California. I've had to replace 3 times in 3 days. Any ideas? put a 100 amp fuse in or call a technician - I think the llatter ...

A/c stops after fuse pulled out then put back in. A/C #2 stops working due to flood in crawl space and water got into the air handlerAir. A/C expert will check it out tommorrow. A/c #1 (airhandler in ...

fuses or limiters on the unit? we replaced the mother board last year because the unit wouldn't run at all (lightening) in our area.......it has worked since mother board was replaced most boards have