Question about Dell UltraSharp Computers & Internet
...LED power remains My Dell 1907FPt LCD was the victim of a power surge. Now the LED powers on and the picture appears for three seconds then disappears but the power LED remains green(not orange). I ...
Question about Dell UltraSharp Computers & Internet
...LED on, but screen is totally black. The VGA signal is good. The power supply has 5V and 12V. Based on the comments, I bought an inverter over eBay, and replaced the old one. But the problem remains. ...
Question about Dell UltraSharp Computers & Internet
...power led show green .again power on /off button off and on the same (power on dispaly on after 2sec diplay off at this time power led ) plz find solution asghar Hi, This is a common problem with LCD ...
...power led button on, if yes, it means the picture board of your monitor is malfunctioning. The picture board on your monitor is bad, since it goes off after few seconds and the power led or button is ...
power or "Led" indicator on the power button, try plugging the power cable to a different power point. If still won't turn-on, try changing the power cable. If still no power. It only means the LCD is
...green power biutoon. Flashing green power button. Verify all cables are secure, try reseating them. If the power led continues to flash, this usually means the power supply in the monitor is
...LED indication. Checked power supply +5V outs are OK. Cable and button board are OK, and I checked 5V to to all buttons OK. But I am getting .5 or .4 V on the G and A LED lines. Do you think the ...
...led's and will not power up. Is this a problem I can solve myself. I am not very electronically inclined. Replace two 10uf capacitors on control board C604 and C507. If you can't solder you will ...
...LED change the power cable then check, if the problem persists take it to the service technician the fault may be in the power supply I had same problem. Changed power cable...nothing. Changed fuse ...
Question about Dell UltraSharp Computers & Internet
...power supply; Got 12V and 5V output from output connector, however, the led on control panel lit up and viola, the monitor worked. It continued to work for about 3 weeks until I had to replace the ...
92 questions posted
Usually answered in minutes!
101 Questions
94 Questions
96 Questions
77 Questions
70 Questions