Question about Cobra Radio Communications
...radio shack. Open the radio's bottom cover where the speaker is. Watch the speaker wires. Near the back right of the board where the power cord plugs in left of the transformer, look for D23. Its the ...
...the battery, bi-passing all ignition noise. Make sure your antenna is getting a good ground, have your SWR checked at a near-by CB shack, or Radio Shack all for free. Thanks for choosing ...
...professionals have a look..Cb shops,Radio Shack, www.copperelectronics.com. Galaxy Radio.Inc.People who service radios; they may charge a good price $$$ though. About $18 to $30/Hr. Labor plus
Question about Radio Shack Radio Communications
where is vr2 or r222 on the rs trc-447? i can't find it i see two TO220's and one TO92. the TO220's are attached to the chassis and the TO92 is on the board. none are near any heat sinks it will be ...
Question about Midland Radio Communications
RADIO SHACK has many 12 volt 3 amp models. Run power wires away from radio about 10 feet away to eliminate hum. AM does hum when its near power lines, household appliances. Keep it away from TV's etc.
...noting where they go, unsolder them with a solder iron. You can purchase them at just about any electronics outlet,(Radio Shack), etc. Then install in reverse removal.....hope this was
...radio shack. Having trouble lowering them. Everything brand new. Don't want to mess up 98vhp. What did I do wrong check that there is a ground connection at the antenna, and that the antenna is not ...
go to www.cbtricks.com they have a service manual for this radio. Check all the 1n4801 diodes for one that is or looks burnt. especially one near the power connector.If you find a burnt one replace it
radio shack, and remove the burnt one, and put the new one in, making sure to put it in with the white strip on the same side as the original. Once you have finished. Make sure the polarity is correct
...radio, get solder pencil at Radio Shack--Carefully solder all little connections on channel selector board near Channel knob. Just reheat them or add tiny amount of solder(with power off of
39 questions posted
Usually answered in minutes!
138 Questions
99 Questions
60 Questions
57 Questions
57 Questions