Question about Cobra Radio Communications
...2000 gtl ? Note: The pin numbers are marked on the end of plug.....#1.shield, #2.white, #3.red, #4.black.....that means #1.shield, #2.audio, #3.transmit, #4.recieve..........hope this
Question about Cobra Radio Communications
...6. Key Mic again and note the actual measurement on the SWR scale. Refer to the following table to interpret the reading. 1:1 - 1.5 Great 1.5 - 2:1 OK 2:1 - 3:1 Not So Good Higher than 3.1:1 ...
...BACK IN THE RADIO A 200 ohm 1-watt resistor across pins 1 & 4 of the mic jack will make some talkback. More or less resistance will make less or more talkback. Note the association of less and
Note - You must have an Armature License to legally perform this conversion. 1. Remove bottom cover from radio. 2. On the main PCB, locate J33. (See diagram above) 3. Locate wires on pins marked "P5"
Question about Radio Shack Radio Communications
...note the actual measurement on the SWR scale. Refer to the following table to interpret the reading. 1:1 - 1.5 Great 1.5 - 2:1 OK 2:1 - 3:1 Not So Good Higher than 3.1:1 Terrible The ideal standing ...
...6. Key Mic again and note the actual measurement on the SWR scale. Refer to the following table to interpret the reading. 1:1 - 1.5 Great 1.5 - 2:1 OK 2:1 - 3:1 Not So Good Higher than 3.1:1 ...
1: Shield and Blue (Mic shield and PTT ground) Pin 2: White (Mic Audio) Pin 3: Red (PTT) Pin 4: No Connection or Mic Return Note: The Yellow and Black wires are not used. I hope this helps, Thank you,
...1 help me my buddy says he can still hear me good I just can not hear them at all in order to hear any thing I have to turn the volume all the way up it appears that the needle still works but no ...
...1 and note the SWR reading on the meter. Go to channel 40 and do the same. If channel 1 SWR is higher than channel 40, then screw the tuning screw out a turn or 2. If channel 40 SWR is higher than ...
...1. Remove bottom cover from radio. 2. On the main PCB, locate J33. (See diagram above) 3. Locate wires on pins marked "P5" (yellow) & "P6" (grey). 4. Cut wire on "P5" (yellow) and install a SPST ...
39 questions posted
Usually answered in minutes!
138 Questions
99 Questions
60 Questions
57 Questions
57 Questions