Question about Frigidaire Washing Machines
...replace motor, motor controller or main control board on my frigidaire affinity washer ( ATF7000FS1 ) after error code E56? Test 9 gives motor winding resistance of 7.2, 7.2 and 7.3 ohms ( spec is 4 ...
...Replace Motor Control Module. Tertiary Source: Rotor Position Sensor (Phase 5 and 6). Action: Replace Rotor Position Sensor. If this corrects the fault, refit the original Display Module or Motor ...
Question about Frigidaire Washing Machines
...3, pin 2 to pin 3). All readings should be between 4 and 6 Ohms. If the readings are correct, replace the speed control board. If the readings are incorrect, replace the motor. No. Replace the ...
...Replace Motor Control Module. If the new Motor Control Module corrects the fault, refit the original Display Module. Phase 5 Primary Source: Pump Action: Measure resistance of pump. If resistance is ...
...Remove rear panel, remove drive belt. Unplug motor lead, undo 2 screws securing motor. Lever back motor with screwdriver, remove motor..Carbons at opp end to motor pulley, remove and replace
Question about Whirlpool Washing Machines
...replace the motor. If it does not have power the problem is elsewhere. Belt If your washer is a belt drive type make sure the belt is tight. Check for black soot from belt wear. Replace if it has ...
Question about Washing Machines
GE Washing Machine Replacement Motor - Capacitor? Relay? Schematic? I am replacing a "clutch-type" GE washing machine motor with a newer "clutch-less" motor. Does the new motor need a Capacitor and ...
Question about Whirlpool Washing Machines
...good, you need to replace hte motor coupling, behind the motor, part number 285753. its the machine equivelint to a belt.easy repair, if needed you can search you tube as how to remove and ...
...replace the motor. If it does not have power the problem is elsewhere. Belt If your washer is a belt drive type make sure the belt is tight. Check for black soot from belt wear. Replace if it has ...
Question about Maytag Washing Machines
Replaced Motor Control, motor and Main Control board, but still won't work Dear washer experts: When I saw the fuse blown in the motor control, I purchased the replacement kit that replaces the old ...
46 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
947 Questions
680 Questions
658 Questions