Maytag Atlantis MAV6000 Top Load Washer "belt tension" Questions

...on the motor to tension the belt - not too much tension though. Holding the motor & belt tension, tighten the motor bracket bolts - job done. Should take no more than twenty minutes to

belt tension too loose I replaced the belts and the new belts are too loose. Is there a way to adjust the belt tension on this model? I don't have a manual and I can't find one online.

...motor. Good luck. the spring has come off the tensioner pulley or the spring may be attatched to the motor and the motor puts tension on the belt look inside for the spring id say its come

...will have a tension pulley to release the tension on the belt. Replace the belt, Adjust the tension on the belt so that when it is tight you can twist the belt 1/4 turn. Please rate this ...

...belt tension. Typical belt tension is 70lbs. While you have the machine open make sure the driven pulley is tight, and doesnt wiggle or move you may have bearing problems. How does the belt look, ...

...belt under tension of a spring hook onto it. Pull and keep the tensioner away by hand to allow the removal of the belt starting at the motor pulley. Replace with the new belt by starting at the ...

...belt tension as well, most washers have an adjustment, normally on the motor that allows you to increase the tension of the belt. If part of a belt gets torn and it is long enough, it will hit any ...

...important that you use the correct size belt or the motor may be damaged and remember to hook the spring back for the tension pulley. The new belt has to go around the inside of the tension

...TENSION THE BELT AGAINST THE MOTOR OR FRAME; THAT COULD LEAD TO DAMAGE TO THE BELT, MOTOR AND BEARINGS- EXPENSIVE! If this has assisted you please consider a 4 thumbs up for the rating. Thanks and ...

...tension belt (drive belt) walks up on to the right/outside edge of the tension pulley (pedal crank pulley). The belt appears to be in good condition. A replacement belt is no longer available. I have ...