Question about Maytag Neptune Washing Machines
what is the value of R-11 in the maytag ,MAH4000 AWW it's in the door lock wax motor for the hinh speed spin The R-11 is on the control board, not in the door lock or wax motor. Value is 3.9KOhm, plus
Question about Maytag Neptune Washing Machines
Neptune TL, stops at the 11 minutes to end and will not go past, I have to shut off, hit spin cycle to finish load Hello krabby64 Is your FAV6800AW or FAV9800AW failing with error codes dc or UC or ...
Maytag Neptune MAH4000AWW What is the resistor R11 (ohms,watts & tolerance) on the control board? Also, Q6 I would like to replace. What is this transistor? I need to know the value of the R11 ...
Question about Maytag Neptune Washing Machines
neptune tl wont empty stuck on 11 and shows nd i blow in to the d i blow in to the drain tude feels blocked water pump may be broke! does it make a funny noise?
Question about Maytag Neptune Washing Machines
i keep getting the dc code during the last 11 minutes of the wash cycle. What's wrong? See this post Clutch Fix to get you started.......Rich
Question about Maytag Neptune Washing Machines
Timer gets to 11 minutes and washer goes into an alarm with the code uc or dc See my post Clutch Fix..............Rich
Question about Maytag Neptune Washing Machines
My Neptune is about 11 years old, on the final spin cycle, it is developing a real high whine, seems to happen more on a heavier load, just started rear bearing bad , cost exceeds valve of machine , ...
...and the display showed dc. The lid was unlocked. We hit the start button and it restarted with 11 minutes left. The most likely cause of a DC error code on a Neptune is the clutch
Question about Maytag Neptune Washing Machines
...CYCLE IT SAYS LR IN SCREEN WAS DOES IT MEAN.? hope this helps ya http://fixitnow.com/wp/2009/03/11/maytag-neptune-front-loading-washer-motor-wont-spin-and-lr-error-code/ Machine does not pump ...
...repair machine control board wax motor lock the wax motor degraded over time and use blew out the R-11 resistor on the machine control its about 200 for both but kinda simple ...
468 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
358 Questions
175 Questions
151 Questions