Maytag HAV2557 Top Load Washer "attach 2 back" Questions

panel foreward and lift up. It will flip back out of the way. Unplug door switch harness. Pull up on and remove 2 retainer clips that attach backing plate to body. Pull up from back and remove housing

2 screws on the back , pull out dispenser drawer, take out the 3 screws from there and the 2 screws on the top of Ctr panel, take off the Ctr panel and flip it back with the wiring still attached then

...2 full in order to get it to spin without wobbling. I need to know which part may be bad, the pads or the o rings I can't find on my service manual. The springs look good, the balance spring in back ...

...back as gravity pulls it in when it is at bottom. My guess is that the Cross piece assemble part 27 appears not to be attached to the drum with part 26 on one of the three attachment points. Not sure ...

...2 wires and a plastic hose attached. Now pull the little hose off and blow down it. Re attach the hose and run the machine. If the error does not return you are all set put the machine back together. ...

...back. NOT ALL THE WAY. just enoough to see under it. you will see a pump. it is attached by 2 hoses. one to the tub and one to the drain. take the 2 clips off with the hoses still attached. tip it ...

2 bands. One that the attaches to the drum, and one that attaches to the front of the washer. The hardest part about replacing the seal, is gaining access to the seal. Once you gain access to the seal

so out of level is not the cause. Any solutions?? Chris Check suspension shocks and springs. undone back cover, should be 3 shocks attached to tub. remove top cover and check 2 springs attached to tub

...in the spin mode. IN FRONT? IF SO, PULL IT OUT AWAY FROM WALL 2 FEET AND LEAN BACK AGAINST WALL. LOOK UNDER MACHINE IN FRONT, PUMP HAS 2 HOSES ATTACHED. IF LEAKING THROUGH PUMP, REPLACE THE

...2 minutes, plug back in and press START) It's on page 9 on the attached manual for your machine. ...