seems to be stuck on the spin cycle and will not spin nor drain. I pulled the back cover off and it appears that the drain motor where 2 hoses are connected with a plastic covered electrical connector
...seems to be stuck on the place where I stopped it. I unplugged it overnight and it didn't make any difference. Machine shows no error code. Just stuck with 8 minutes left on final spin and will not ...
Question about Maytag Neptune Washing Machines
The washer spins slowly will not drain water out. Seems to be stuck in the wash cycle. Check / clean filter...And or pump
Question about Maytag Neptune Washing Machines
...seems to occur near end of rinse cycle (according to bars on display). Never gets to drain/spin part of rinse cycle. if the water continues to fill even with power off, and you have to manually shut ...
...seems to lie in the rubber backed mat. If the rubber has begun to peel of the mat it often-times get stuck in the drain pump. The best thing to do at this point is to disconnect the electrical cord, ...
Question about Maytag Neptune Washing Machines
...seems to get stuck when it comes time to spin. I hear it start, then it stops and timer does not change. Water at bottom of machine, about 3 inches will not drain. Spin only does not do anything. No ...
...seems to be a definite stuck pressure switch not water inlet valve such as yours. Check to make sure your pressure switch is OK by watching the fill point transitions as I mention in the post. If you ...
...seems to be doing fine. Any suggestions?? If it?s a FAV6800AW or FAV9800AW the Control Board is under warranty for five years from date of purchase. I?ll assume it is and attach a link to the service ...
Question about Maytag Neptune Washing Machines
...seems to get stuck at 32 minutes. It doesn’t drain either but I can do manually by going to the diagnostic mode. Any one have a solution for this one? You have a Series 10 machine 1st two digits of ...
...stuck open or infinite resistance). It seems to have some rod of metal in it that moves back and forth with the washers motion, so I just shook it vigorously and you could hear the rod of metal ...
24 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
358 Questions
175 Questions
151 Questions