...remove the rear inspection panel...(5 screws) from the top of the machine offer the belt down to the motor pully...fitting it over the pully (middle of the motor pully)...bring the belt as far around ...
...drive the spin cycle has become lose and is causing the belt to frey because it is saging down. How do I tighten the pully mechanism? Remove the pulley from the shaft (the large drum pulley?) and ...
...remove the panel. If the lower cabinet appears to be one piece, this may be a belt-less direct-drive type of machine in which the entire cabinet is removed after releasing the top. In these machines, ...
...drive pully when i turn drum wheel by hand. machine not that old and belt in good condition (checked it against new one). how do i refit belt and make it stay on Hi from retired Englishman in SW ...
...Remove the front panel. There are 2 clips, about 4 inches in from the corner, that can be seen thru the crack between the top and the front panel. Push them, with a putty knife, to the rear,while ...
Question about Whirlpool Washing Machines
...drive pully I have had the belt replaced twice, but the belt continues to slide off of the pulley. A new belt kept it going for about 2 months. I check the back of the washing machine and the belt ...
...drive belt un plug appliance, remove lid and back plate, place belt on motor and carefully on drum pully, turn pully to pull belt onto its, its quite tight to do but is possible, watch out for ...
...drive belt is broken , how do I replace it? Remove the back hook it on the motor pully and start to wrap it around the drum pully until it is to tight to continue then turn the drum pully to finish ...
Question about Hotpoint Washing Machines
...the drive belt and pully and unhooking from the suspension then separate the plastic outer drum from its two halves remove the inner drum and knock out the bearing, replace all in reverse
Question about Kenmore Washing Machines
...REMOVE THEM AND THE PANEL YOU SHOULD SEE THE DRIVE BELT CONECTED TO DRUM PULLY AND THE DRIVE MOTOR LOOK FOR A TENSIONOR LOOSEN IT AND REMOVE BELT TAKE THE BELT TO AN ELECTRICAL AND PLUMMERS SUPLLY ...
36 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
947 Questions
680 Questions
658 Questions