Maytag SAV2555A Top Load Washer "old inglis washing machine spinning" Questions

...old. I am trying to save a repair bill because I live an hour from the nearest large town. Help please!!! Thank you and God Bless Always remember Electricity is dangerous and should be treated with ...

whirlpool ingis washer will not engage rinse cycle I have a whirlpool ingis washer 2 years old. It will not go into the rinse cycle. The washer does nothing when in the rinse cycle. The washer will go

...Inglis IP44002 Top Loading Washer This washing machine is only 2 years old. I am able to start the load but when it's done filling with water it doesnt spin or do anything despite adjusting the knob. ...

machine is being shaken the most and at a high frequency) I pulled the control card and reflowed all the solder joints, took care of the problem for a few months. The problem returned. I reasoned that

...old. The washer has stopped after the initial wash cycle leaving the cloths wet in a tub full of water. The washer will not go to the spin/drain cycle. The lid can be opened and when shut and reset ...

...OLD) WILL NOT COMPLETE SPIN CYCLE. IT STOPS BEFORE GETTING TO FULL SPEED, REPORTS AN OFF BALANCE ERROR CODE. IMPOSSIBLE TO BALANCE - FROM TOWELS, SHEETS, REGULAR CLOTHES - MAKES NO DIFFERENCE WHAT I ...

...old inglis belt drive top load washer agitator intermittantly "slips" (stops rotation sometimes in one or both directions) while on wash or rinse cycle. Transmission makes a klunking sound when this ...

...machine is in when the high pitch sqeal begins then shut it off. Will wait for you answer Elmer, My (ancient...but workhorse) Maytag A512 just started to smell and not agitate during the wash cycle. ...

machine is less than 3years old then this is what bust hotpoint they changed the bearing setup and put a spring on it which its the spring that is the complete failure u need to take the complete drum

...inglis that is 5yrs old but will not spin they say my machine is drict drive it will was and drain but will not spin on any setting ... thanks.... townie This is usually caused by the motor coupler. ...