3Com 4500 24-Port Ethernet Switch "console config" Questions

...console# config console(config)# interface vlan 1 console(config-if)# ip address 10.10.90.222 255.255.0.0 console(config-if)# ip http port 80 console(config-if)# ip default-gateway ...

...config 8. eate new passwords for the 3750 switch with the following commands: conf t enable secret spswd (spswd = your new secret password) enable password enpswd (enpswd = your new enable password) ...

...console password Sw1(config−line)#line con 0 Sw1(config−line)#password Write the running configuration to the configuration file with the write memory command. Sw1#write memory Building ...

...console cable and physical access. Connect it at 38400/8/n/1 through Hyperterm or Putty or whatever terminal app you have. Press Ctrl+U while the switch is booting From the menu select Delete type ...

to do that? product: catalyst 2948G-GE-TX You will have to reset the switch and intercept the boot into ROMON mode, then load the config file and change the console password, wright the mem and reload

...console plz give reply as early as possible. login through telnet, remove the current username and password. configure the username with the new password config t username xxxx pass xxxx 1. do not ...

...config 8. eate new passwords for the 3750 switch with the following commands: conf t enable secret spswd (spswd = your new secret password) enable password enpswd (enpswd = your new enable password) ...

...console port of the switch and type in the interface this: - enable - config t - write erase -(you should be promoted here type 'y') - reload -(should be promoted again type 'n') -(should be promoted ...

console port of the switch. Use the following terminal settings: 9600 baud rate No parity 8 data bits No stop bit Unplug the power cable. Hold down the mode button while reconnecting the power cord to

...console port of the switch. Use the following terminal settings: Bits per second (baud): 9600 Data bits: 8 Parity: None Stop bits: 1 Flow Control: Xon/Xoff 2.Unplug the power cable. 3. Hold down the ...