Maytag Atlantis MAV6451 Top Load Washer "water tub non" Questions

...water Sounds like a tub support could be defective causing excessive tub movement splashing water outside the washer. Try to move the tub by hand and see if it is firm and snaps back to its center ...

...water in tub after non-use the washer runs fine, replaced pump 2 months ago for error code f-02. Now water is in tub when not in use. Sounds like you need to check your water inlet valves and make ...

...WATER RUNS NON STOP THROUGH MY WASHER. IS THERE SOME TYPE OF PRESSURE SWITCH. THX JOE Yes. on Maytag usually runs fro left rear of tub to the control panel. You will have to pop the lid up to get to ...

...tub filled with water and now the tub is filled with water and won't empty or continue Check to make sure the safety switch under the lid is being made. Use a popsicle stick or some other non ...

Tub Spinner. The basket will spin, but the water won't drain out of it? I took the clothes out after the spin cycle, and the basket is about a third full of water, yet the washing machine side empties

...tub), a pin hole in the water pump or hoses, or a bad tub seal. Ideally you need to take the top off of the machine and run it to determine where exactly the water is coming from. One other thing to ...

water all drains out. A worn or damaged belt can cause your problem. Always replace the drive belt and pump belt at the same time. Check for smooth and non binding motion of the motor in it's carriage

...tub 800 stopped draining water at washing cycle drum. I removed all hoses at drain pump motor an found a flat black round rubber, which to me looks like a plunger to shut off water from drain cycle ...

...reoccurring odors. You can also try the same type of cycle on hot water with a half of a gallon of bleach in the tub, or try it with a half of a gallon of vinegar. One of the 3 should do the

...water in the tub Triple Spray technology and auto load sensing I've had the same problem..3 times in 2 years. EVERY time I needed to relpace the switch sensor (behind the water temp knob.) It fixes ...