Question about Hotpoint Washing Machines
...makes loud popping the washer dryer was on a 45 minute drying cycle, loud popping noise heard then fuse went. Husband replaced fuse now machine will wash ok but I can't use the dryer. Please help. ...
Question about Washing Machines
washing machine is making a loud popping noise when NOT running. It just started doing this randomly in the middle of the night. It of course stopped when we unplugged it. Someone on this site said to
Question about Whirlpool Washing Machines
...washing machine popping clicking during fill and spin The machine makes a loud popping or clicking sound while filling, even on TAP COLD setting. IT also makes this noise randomly and excessively ...
...washing machine makes loud popping noise when "goes into high gear" on spin cycle but still spins slow and belt is not slipping Hi, A loud popping noise could be a fault in the electrical capacitor ...
...if these 2 are connected but it makes a noise when filling it a pop but not as loud.. This is a sign that the transmission is failing, If you post the model number we may be able to help you
...washing machine Loud when spinning Make sure the load is balanced and check the springs on top and make sure they are all attached. You can pop the top up with a flathead screwdriver and rag to keep ...
...washing machine My washing machine this week has been making a very loud noise when in just about every aspect of the wash. My husband opened it up and looked under the plastic seal and noticed ...
Machine making a loud noise in spin cycle. We Machine making a loud noise in spin cycle as though it is out of balance. However this noise happens even when there is no laundry in the machine. The ...
...loud pop and then smelled burning rubber. My husband has pulled the belt off the bottom and its still in one piece but there is little pieces of burnt rubber falling off from somewhere. The motor and ...
...loud knocking noise during wash cycle, machine is almost a year old.Please advise Use a screwdriver to remove the screws holding down the control panel,then swing it upwards. Use a flat blade ...
317 questions posted
Usually answered in minutes!
2,979 Questions
1,498 Questions
947 Questions
680 Questions
658 Questions