Maytag Neptune FAV6800AW Top Load Washer "pressure trickle" Questions

trickle in. Also must run another spin cycle most times but not all. Does having the units on a base help this situation? Either your inlet valve is clogged or the pressure of your wall faucet is low.

...pressure to spray an appliance that is next to the washer and the back of the washer -- at the same level as the drain pipe opening. This just occurred while we were on vacation, had the water feeds ...

...pressure and to clear out any debris from the line. Inspect the filter screens on both the hoses and the inlet valve for debris build up. If you find any debris, clean it out. Use caution to avoid ...

cold water only trickles in... Cold water only trickles in Assuming you have good water pressure to the inlet valve, you probably have a blocked or faulty inlet valve...Not a big job....Good ...

the screens clean and install. If they are not dirty your inlet valves are bad. Also has your water pressure seem any less in pressure? Good luck

...of the hose for filter, or in the inlet to the valve. If no filter, then prob could be low water pressure, or faulty inlet valve. Please rate my solution.

...garden hose connectors, remove filter, clean, replace. When filling with hot only you get a lot of pressure thru one hose. When you rinse, the best you can do pressure-wise is cold rinse -- but the ...

...have checked the fitting the water comes out of - everything seems clear. Have checked water pressure coming out of the tub tap and it is very strong. Can't figure out what the problem is. ...

...screws onto it. There may be a filter/seal where the hose screws onto the tap. If there is water pressure to the inlet valve, it could be that the inlet valve itself is faulty........Generally a ...

...trickle, it's most likely closing before it's supposed to. Also, you may have a defect in your load selection switch. There is a hose that goes from that switch to the inlet valve. When there is so ...