where is the jp4 connector? where is the jp4 connector on the motor control board of the maytag neptune TL washer? Blue,Red Yellow and two White wires on the connector. It.s not labled on the Control ...
Question about Maytag Neptune Washing Machines
...rotor. You need a new motor usually comes in a kit .12002039 is the part number. Try unplugging the jp4 connecter and see what happens. QUESTION: Where is the jp4 connector located? maytag neptune ...
MAH5500B won't spin. LR displays. that means locked rotor you need a new motor usually comes in a kit 12002039 is the part numberr try unplugging the jp4 connecter and see what happens
Question about Maytag Neptune Washing Machines
...test" as specified in the service manual: * Disconnect the power * Open washer and disconnect the JP4 Connector from the Motor Control Board * Reconnect Power * Go into Service Mode (press Enviro ...
...at it though check the main control board for failure such as a burnt resistor on board... usually jp4 resistor on board.. if the board looks good then probley going to be the motor controller
Question about Maytag Neptune Washing Machines
...DC error code then - no error codes now. Lid unlock problem indicated Motor control problem. Pulled JP4 and ran service mode tests and everything seems fine (even pumped out the dirty water for me) ...
Question about Maytag Neptune Washing Machines
...the motor control board. Do you have a delay wash cycle? If you do set it to delay wash remove the jp4 connector if the unit tumbles on it's own then the motor controller is fine but if it does not ...
Question about Maytag Neptune Washing Machines
...door back on and close it. Unplug the washer. On the motor control board, bottom right, pull the JP4 harness connector from the board. Plug the washer back in and make sure the door is closed. ...
...checked the fuse on the motor control board and it appears to be OK. I then proceeded to remove the JP4 connector, started the machine on a 6 hour delay and could not hear the motor start at all. ...
...guessing it was turning at 50 RPM. I'm not going to try and count them :)So I hooked the JP4 back up and for the fun I tried a load and it worked fine. Figured maybe I dislodged a ...
1,827 questions posted
Usually answered in minutes!
2,979 Questions
358 Questions
175 Questions
151 Questions