...atc sensor or atc contol board could be causing the problem. 1st make sure you are getting water to the machine hot and cold. If you water valve is not opening for one or the other it would be the ...
...sensor that lasted for a month and the other repair guy reversed my hot and cold hoses that really didn't fix the problem. If I want a cold wash I have to set it on hot and run over when it starts to ...
Question about Whirlpool Washing Machines
...was bad. $70 later I have a new timer and the same problem. Could the ATC switch/sensor be the problem ? it could be the sensor bad u can go to appliancerepairplanet.vstore.ca for help in this ...
...ATC Thermistor is detected to be open or shorted. See TEST #5, page 11. Motor RPS Thermistor Open/Short F then 41 flashes when the motor rotor position sensor (RPS) thermistor is detected to be open ...
...ATC). A sensor will control water temperature and ensure cold washes are above 60 degrees (F) to dissolve detergents, and warm washes do not exceed 93 degrees (F) to help prevent shrinking and ...
...sensor. Called the Maytag repairman and it cost us $184 for him to replace the ATC module on the left top side of the control panel. It took him less than 2 minutes to switch out the ...
...sensor or the ATC control board are not at fault. Seems that the only thing left is the motorized controller. I was partially wrong on my diagnosis. No cold water enters on either the wash or the ...
Question about Maytag Neptune Washing Machines
...There is no blockage of the hose and the water source is good and strong. If it is equipped with ATC automatic temp control turn it off and see if if you can get cold if so its the ATC ...
1,827 questions posted
Usually answered in minutes!
2,979 Questions
358 Questions
175 Questions
151 Questions