Question about Maytag Neptune Washing Machines
...rear and out of the clothes area. The drum does rotate freely with the exception of the subbing noise that when unloaded is mild. All supports appear to be intact, and there does not appear to be any ...
drum. I would be careful not to burn the motor (About $120 - part only) You should be able to access and inspect the drive-belt in the rear of the machine by removing an access panel (back of washer).
...drum is not moving and the water is not coming in or spining out The LR error on your non-spinning Maytag Neptune is usually, though not always, accompanied either by a burn spot or a blown fuse on ...
Question about Maytag Neptune Washing Machines
...drum off and on about every 30 seconds for a second at a time even after pressing the off button.showed error codes sd and lr.have gotten it to spin out in the past but started clunking like load was ...
...and making a loud noise. Can you help? You have a big problem . Sounds like the (spider) on the rear of the inner drum is broken. Means a new drum and rear tub plus about two hours labour to
drum held steady by bearings in the rear of the unit? There is one bearing in rear tub/bearing is part of rear tub...To repair that unit you will need a rear tub/inner basket with spindal and possible
Question about LG Washing Machines
rear bearing assembly has collapsed or because the drum is distorted. Turn the drum slowly by hand and see if the gap between the rim of the drum and the rubber seal stays the same. This will tell you
I can move the drum in an out and on final spin it makes a nosie and smoke came out when i opened the door. check on your warranty sounds like a rear bearing and tub issue part around $300.00
Question about Washing Machines
...replacing the rear bearings on my HE3t front loader washer , my machine on spin now has smoke coming out of it. Any suggestions? possible bad motor belt or transmission or drum isnt seated ...
drum held steady by bearings in the rear of the unit? I am having the same problem. Did you find a solution. Our washer is just a little over 2 years old and I am trying to decide if I should just cut
3,973 questions posted
Usually answered in minutes!
1,498 Questions
358 Questions
175 Questions
151 Questions