Maytag PYE2300AY Electric Dryer "hot edge door" Questions

...hot/damp air out The door was jammed recently and needed a strong pull to open it. Although the door lock and catch don't look broken, ever since then the tumble dryer is leaking warm wet air out of ...

...hot for several reasons: Motor going bad Lint around motor causing it to retain heat Vent system open at some point inside or behind case allowing heated air to remain in motor areaFollow the ...

...hot air is drawn from the hearer at the rear of the drum, through the drum then through the fluf filter at the front (inside the front edge) and then down the front panel and to the fan, then via a ...

...it in hot water and detergent to remove fabric softener deposits. Vacuum below the lint filter opening as far as you can reach and inside the door cavity (be careful of sharp edges!). Hope this

...hot if not vented prioperly unplug the drier pull it out from the wall about a foot facing the drier take a small putty knife and insert it about 3" from the edge push the knife in till you feel the ...

...hot water and detergent to remove the fabric softener deposits. Remove the external vent hose and clean the lint from it and the outside shutter assembly. Vacuum below the lint filter and from the ...

...hot inside, but the clothes stay wet. I have checked the lint filter, vent, and the hose is clear. I have noticed condensation on the inside edges of the door and some underneath the dryer. Is there ...

Hot point TCM570 tumble dryer drum not turning? Hi I have taken the top off the machine and can see a black belt round the middle of the outer drum. It has some slack to it, I have tried turning the ...

...lint as well (watch out for sharp metal edges around any openings in the interior door panel). Wash out the lint filter in detergent and HOT water to remove fabric softener deposits. Hope this

...hot rather quickly to dry clothes. But, with that being said, check the entire exhaust pipe to make sure you don't have any blockage that might be causing a venting problem - you want the vent pipe ...