...fuse on the printed circuit board of the power supply. The problem is getting into the power supply housing. It's not meant to be accessed but can be done. I removed mine from the board and it tested ...
Question about Canon PIXMA Office Equipment & Supplies
...from the output. please you buy any old printer same model or reaper it change fuse I will be honest on this. Your best bet is to replace the power supply. It only runs about 20 - 30 dollars on
...new power cord and still nothing. hi did you mean dead set?check the fuse on the power supply.you can see it by opening the the back to where the power cord is inserted..replace the fuse if
...if no change the printer has a power supply problem, I usually find a blown fuse, shorted diodes, and sometimes a bad capacitor, and additional issues, you may find it cheaper to replace the
Question about Canon PIXMA Office Equipment & Supplies
...power supply which is a SMPS- switch mode poweer supply. Start from the fuse, the surge protector which could be short or the mains rectifier, mains capaccitor or the SM driver. Replace and ...
...fuse in the MP630. It has a internal solid block power supply. You cannot open it only replace it. Just make sure you have no keys stuck down on the operation panel. If all ok then its more likely ...
Question about Canon PIXMA Office Equipment & Supplies
...power supply cord is fine. hi, 1.Make sure powerchord connected properly&turn the switch ON. 2.Fuse has damaged due to excess/Voltage variations(inside Printer Board),you have to replace the
Question about Canon PIXMA Office Equipment & Supplies
...fuse, probably on the power supply board, to protect against the possibility of fire. Unfortunately, these are not normally user replaceable as they are often 'micro' fuses in a cylindrical ...
...fuse in the plug (UK). Are you getting outputs on the power supply in the machine. If you are then the logic board has blown and requires replacing. If you are not getting outputs from the power ...
Question about Canon PIXMA Office Equipment & Supplies
...power supply? No fuse or breaker on this model, Most times this problem is caused by a bad printhead. When they go bad it doesn't allow the printer to power up. If the printhead is not locked in the ...
1,992 questions posted
Usually answered in minutes!
2,244 Questions
2,149 Questions
1,862 Questions
1,302 Questions
1,216 Questions