Question about Canon PIXMA Office Equipment & Supplies
...bar that normally grabs the paper will not move any quick fixes for this. If you can get to the rollers, get some fine grit sand paper and rough up the surface a little (Make sure you do it even ...
Question about Canon PIXMA Office Equipment & Supplies
bar parks itself under the roller section, and the document gets scanned as it rolls past the stationary bar. A spot or speck that blocks the light bar as the document rolls past manifests itself as a
...roller beneath the bar should roll towards you but not backwards. If it goes backward the overdrive clutch needs to be oiled. Not easy to get to, you have to remove the top cover and left side cover ...
roller instead of peeling off. Here is a link to order parts and get very good and professional people to deal with. This IS NOT me or where I work, but the best I found bar NONE for Xerox parts, When
...roller or a bar to hang the labels on, correct? The bar has an adjustable stop to keep the roll from moving around while you print. You may want to setup the media sensor about 1 cm from the left of ...
Question about Canon PIXMA Office Equipment & Supplies
...bar every other label I print? How do I properly clean the Z4Mplus? The labels print, but will wrap around the roller quite frequently. Thanks! Try a different roll of labels. Clean with 100% ...
Question about Canon PIXMA Office Equipment & Supplies
...in 90% isopropyl alcohol (it will be messy). You will have to use multiple paper towels. Check all rollers and insure they will roll. Check the carriage and drive belt for damage. I would also spray ...
...When I print pictures using photo paper, they come out with a longitudinal mark (like if one of the rollers were pressing the paper too much). The mark is always in the same side (center-right). I ...
...tools pathway to run a Xerograhic set-up. Any suggetions? What usually causes that problem is a bad roller in the developer housing. It builds up ink and will not set up correctly. The second problem ...
Question about Canon PIXMA Office Equipment & Supplies
bar covering the roller (again two screws) and placed it on one side. The T-shirt paper had rolled itself completely round the rubber roller to approximately 3 thicknesses and the heat had glued parts
245 questions posted
Usually answered in minutes!
2,244 Questions
2,149 Questions
1,862 Questions
1,594 Questions
1,302 Questions