Maytag Atlantis MDE6400AY Electric Dryer "thermal fuse sears heat vent" Questions

...thermal fuse, very simple and affordable to replace. To replace the thermal fuse just remove back cover of dryer and look down where the air blows out. Now, just to the left where all the wires are ...

...thermal fuse and hi limit ther Want to avoid repairman. How do I access the thermal fuse? You are on the right trac.The easyest way to check the thermal fuses is to follow the wires from the heater ...

Thermal fuse Most dryers have a thermal fuse, which burns out when the dryer overheats, in which case the dryer will either not run at all or stop heating. The fuse is usually located on the vent duct

thermal fuse,it has 2 terminals and is 1" long by 1/4" wide and is white in color,it should show 0 ohms,otherwise bypass it for testing by jumping c(touching wires together)  and plugging it back

...thermal fuse be blown because the vent duct work(foil) kept falling off & didn't realize for quite sometime that The Sears tech. who installed it used metal foil duct work which after reading the ...

...thermal fuse has blown. If you look up your model on sears.com you can look at the break down to locate the fuse. These parts usually go because of overheating, caused by vent issues. Restrictions, ...

...out fine. Are there any other easy things for me to try? Thanks for any help you can provide! Possibly a bad thermal fuse/or igniter.I'll be happy to guide you through this. ...

...thermal fuse blew you would have no heat, I would suggest to make sure you have a clean vent system to assure the dryer can breath. Simple test, disconnect vent system and run dryer, if the vent ...

...thermal fuse and said to take leads off and tape them together (bypass the thermal fuse) and if it heated, the thermal fuse was the problem. it didn't heat up then either. what's the next thing to ...

...thermal fuse (0 ohms), the thermistor (0 ohms), the Thermal cut-off fuse (0 ohms), the fixed thermistor, and the element (max ohms). I know the thermal fuse and element readings are correct. Are the ...