Maytag Neptune MCG8000AW Gas Dryer "burner stays high" Questions

burner goes off after 5 seconds if ijump the high limit switch it stays on Replace the high limit switch. Here is a link to the part.

...high-limit thermostat both on the burner tube if the sensor doesn't see(sense) a flame the gas valve will stay shut,then check the gas valve coils,both the BOOST and SECONDARY coil valves on the gas ...

...the burner comes on but it will only stay on for a short time and the flame will go out Check the vent pathway. Perhaps the theromstat is sensing high temp due to restricted air flow and kicking

...burner cycles on about every min or so, stays on for about 10-15 secs then goes out. Thanks, Steve hi..A poor connection between the wire terminals and the heater relay causes high current draw and ...

...high heavy. I am thinking I have a bad solenoid. Any ideas where to go next? Is there an internal flap/damper in the exhaust vent that could be staying closed and causing it to run hot and the burner ...

...burner is not active.  Intermittent problems are very hard to troubleshoot so you need to write down every indication and when it happens.  For example:  Works good on permanet press, ...

...stays on. That's the reason I changed the high limit thermostat but did not fix problem. Should I change the other thermostat installed on top of the duct from drum. Or should I do something else. ...

...the igniter glows bright,turn the switch off and the burner will light if it stays lit at least till it gets to temp replace the flame sensor.(It won't cycle with out flipping the switch each

...stays on for 3 to 4 seconds not raelly heating up the dryer it can be the high limit thermostat,the flame sensor eye on the burner tube,or the cycling thermostat on the blower housing you can try ...

burner will not heat in the center unless turned on high settings. The outside element stays hot when on any of the high settings. Center comes on when on high. Replace your infinite control (its what