...technical support, if the status light flashes red six times, this could indicate a defective lamp. If a new lamp is installed and the project still won't turn on, the projector will need
Question about Optoma Office Equipment & Supplies
...LAMP WARNING light keeps flashing, still won't turn on? I turn my projector on and the power light goes solid green. Then after a few green light blinks the LAMP WARNING light turns red and the ...
Question about BenQ Office Equipment & Supplies
won:t turn on. The temp light is Green and the Lamp light is Yellow. Do I need to replace the lamp, has it gone bad? Yes. Here's a cheap one on E-bay, too. http://cgi.ebay.com/MP670-W600-W600-benq
...lamp light amber won't project. I was given a reset key stroke for the projector to reset the error light but don't remember what it was can you provide? hi, To reset the lamp hour of you ...
...lamp and it worked for about 3 hours and then when we tried to turn it on again, it won't fire up. Sometimes if I hold down the power button the orange light will flash slowly. Could it be the ...
Question about Hitachi Office Equipment & Supplies
...lamp) dont light. It seems like the normal Stand-By, as described in the manual. But at this point it won´t go any further, I can not start the Projector by pressing Power switch either on Remote or ...
Question about Panasonic Office Equipment & Supplies
lamp timer? In projectors, they won't just give you annoying message via "on screen display". It might think, that you never replaced the lamp, just took it out and put back in. You must reset the
Question about NEC Office Equipment & Supplies
Won't come on. Power light orange Status red Blincks Once every sec or so. If the lamp life has exceded its safe working limit, it will probably go into a permanent standby mode, I used to have an
Projector shut off My projector shut off during a movie. The Led lights turned red. It won´t turn on.Help! Your lamp may well have died..
Question about InFocus Office Equipment & Supplies
...projector won't turn on The lamp life may have exceeded its safe limit, check your manual as you may have to press a specific button on the unit/remote for a length of time to reset it. Good ...
22 questions posted
Usually answered in minutes!
400 Questions
218 Questions
72 Questions
80 Questions
76 Questions