If it is DSL modems, you just have to access the setup page of your device to configure it using PPPoE,
DHCP or bridge mode. If it is a cable modem, either you install the drivers for USB connection between the computer and modem or just
more...
to change ipw2100 to ipw2200 in Makefile and *.c. I
have a feeling, I achieved some progress, but my eth1 still does not
obtain
DHCP address. :(
--
Best regards,
(js).
PS. When responding directly, please remove a dash with all the
following letters.
more...
you need to get into your routers settings and make sure that
DHCP is enabled to automatically assign ip addreses and also go to the properties of your wireless adapter and ensure obtain ip address automatically is
more...
during installation. Oddly enough, the built-in
ethernet did not originally work. After install, both worked fine.
I did nothing other than check to make sure
DHCP was set on both interfaces
Which port is your wlan? eth1 or eth0?
--
k
more...
is a built-in Intel WLAN interface
- I cannot make work
- it does not associate with an AP
- it does not obtain
DHCP address
- set up for manual start
- I have no external means to check, if the radio gets turned on
- It works
more...
But the best thing is to be sure that the network card in the computer is to "Obtain an IP Address" and that the
DHCP server is enabled when looking at the services. Jeff
more...
Sponsored Links