Maytag PDB3600A Built-in Dishwasher "causes clean light stay" Questions

...causes: The door opened during the cycle, or the power was interrupted. To resume operation: Make sure the door is closed, and press Start/Resume. The Clean light is flashing You should call for ...

...clean light stays on even when dishwasher is off and empty Hello...Most likely the LED is shorted causing the light to be on...I'm assuming you've opened the door, emptied the unit, then closed the ...

...clean light but I did "the 4 button sequence" again, waited several minutes with all the lights on and then hit the cancel and now my dishwasher is able to work again. YEAH!!! Note: I did clean out ...

...clean the things... Bought new spray arms online and installed them in minutes...now the thing works like new... However I have also found that if the heating element goes bad then that also can mess ...

...clean light stays on and it wont do anything else This information may help in your situation. The following link explains how you may be able to clear the blinking clean light problem: ...

...Clean light stays onThe dishwasher won't start a new cycle unless it detects that the door opened after the previous cycle.Turn off power to the dishwasher by shutting off the breaker and restarting. ...

...clean light comes on flashing. had a repair man in changed circut board. month later of same issues told us the drain was not connected properly. today had a service man in and a wire was off to the ...

...light- Clean cycle Cannot get my WHirlpool -gold, Quiet Partner III to re-set. It got froze in the middle of a cycle ( someone opend door and didn't shut.) SO when I hit the reset, it cleared the ...

...clean the things... Bought new spray arms online and installed them inminutes...now the thing works like new... However I have also found that if theheating element goes bad then that also can mess ...

...clean light is still flashing and heat/dry light stays a constant green. Can I be pushing a wrong sequence of buttons and can I get a definitive answer that if the control panel is not responding it ...