Question about Kenmore Refrigerators
...plastic shell and the outer metal covering. The problem you describe is caused by the hot gas pipe that runs around the cabinet, this is normal for it too get warm, the only reason it would be very ...
...around plastic chute in center back of freezer. Not from icemaker. How to get plastic chute out to see defrost drain, etc? use hair dryer but do it gently. turn the unit off. the drain is in the back ...
...around 24 degrees even though it is set for 0. I never noticed the surface heat before but that doesn't mean it hasn't been a problem for a while; our electric bills are at least double what they ...
...plastic shell of the refrigerator. It could be burning through the insulation of the fridge right before it shorts something out or starts a fire. Refrigerators and fires should be opposites. If the ...
Question about Samsung Refrigerators
...position and will not turn. get a hair dryer and blow the hot air around where it lucks. push filter in and turn to unlock it. hot air expand the lucking plastic cover and it allows for easy ...
...plastic coating from it. Wrap one or two tight turns around the defrost heater. put the other end down the defrost drain. This is not recommended for glass tube type heaters. just metal heaters. Do ...
...plastic water line running around in back and/or bottom of the fridge, that the water in the line is getting heated up by being in contact with the condensor coils or the compressor, etc. No doubt, ...
...plastic cover around 15mm diameter inside the fridge or freezer, remove the cover and rotate the timer clockwise until you hear a firm "click" then plug the fridge into the power & see if it starts ...
...around the coils they defrost approx. every 12-16 hours if the defrost cycle gets stuck then it will continue to heat i have seen it melt the plastic inside the refrigerator possible causes: bad ...
...around it pour hot water into the back of it wear the ice drops thou don't for get to put a cup in first.thats what i did after taking of the square plastic framing and sliding out the rubber ...
48 questions posted
Usually answered in minutes!
822 Questions
518 Questions
315 Questions
239 Questions