Question about Ricoh Aficio Office Equipment & Supplies
...you can purchase just the oil supply portion of the fusing unit and replace that (part #G0604022). I'm not sure how much that would cost, but it's got to be cheaper than a whole new fusing
...Fusing unit is not set properly". Any idea ? The old one and the new look the same... I don't see what is wrong. There was a message in the box : "Donot turn the blue dial at the side...". I didn't ...
Replace fusing unit error I replaced the fusing unit in my ap3800c today but am now getting an error message "replace fusing unit type c" which has also locked the machine. I am unable to get into the
...Pressure roller fusing lamp When the fusing unit is not running in the Ready condition, the pressure roller fusing lamp keeps ON with full power for 100 consecutive seconds. Replace the fusing
Question about Ricoh Aficio Office Equipment & Supplies
...transfer unit. Defective PCU. Replace the PCU. Defective transfer roller. Repair the transfer roller. Defective fusing unit. Replace the fusing unit. Defective engine board. Replace the engine
...broken • Defective pressure roller thermistor • Defective BCU Troubleshooting Procedure: 1. Check if the pressure roller thermistor is firmly connected. 2. Replace the fusing unit. 3. Replace the
...Replace Fusing Unit", which we have done. After that the instructions say to hold down the Escape key for 5 seconds, then enter the Maintenance menu to reset the counter for the Fusing Unit, but this ...
...fusing unit Replace the fusing unit. 4.3.11 DARK IRREGULAR STREAKS ON PRINTS Symptom Possible cause Necessary actions Unexpected streaks appear at irregular intervals. Defective transfer belt Replace ...
...fusing unit that monitor the temperature of the unit. This code means that the thermistors are either not "seeing" or reading any heat from the unit or for some reason the heater lamps are not coming ...
Question about Ricoh Aficio Office Equipment & Supplies
...? ? After the technician replaces the fusing unit, the maintenance counter must be reset with engine SP mode 7-804. ? 7-804-1: Transfer roller ? 7-804-2: Paper feed roller ? 7-804-3: Fusing
384 questions posted
Usually answered in minutes!
215 Questions
218 Questions
178 Questions
117 Questions
137 Questions