Samsung ML 1610 Laser Printer "paper stuck tray" Questions

...paper gets stuck in the middle of printing. Page only goes half-way through before stopping. I have to constantly open front cover and top cover to keep paper flow continuing. Many times half of the ...

...paper got stuck under the toner, you will have to check is there any florin object stuck in the gab in the way for the paper to run smoothly. 2. If the paper got jam at the back of the printer near ...

...jam 2?? check paper stuck from tray to roller going out, if no visible tear paper inside, if clear check possible sensor key some on that disconnected from housing and didn't touch to sensor

paper is still stuck in the rollers. Make sure also that the paper feeder is properly placed on its correct location. Other things you can do is to put some more paper on the tray. See if it will feed

paper sheet stuck underneat the printer. Open front door, pull out toner and chech under toner, put toner back , restart and try. Open back door and check if there is a second paper sheet stuck inside

...stuck. But 1st things 1st did you check if the tray lifts to take the paper? or try to take the paper atleast? if not then you can try to wiggle the printer a little and you should fine some thing ...

...paper stuck. apparently, some folks have said that it's best to take the fuse from the cartridge. i don't see this at all...and don't know how to do it. It's a very short paper path, you should see a ...

...paper jammed in there to make the light come on. Use a flashlight and try blowing some air through it with the tray out, back door open and cartridge removed. Rob Thanks for ratings. I have a problem ...

...paper tray take ot put it back. Rafique I had this problem. The cancel button was stucked. Open the toner tray and slighly push the button side top-cover up. It released the cancel button for me ...

stuck to the roller, this may cause it not to grip properly. You can also try a few sheets at a time and make sure the paper tray is gripping the paper, but not too hard. If this fails, the roller may