...a c-bracket that the storage bin slides into --- the motor may have to be replaced that turns the spiral feeder inside of the storage ...
...it won't dispense out of the door. Just a suggestion. Remove the ice tray and the ice. Do you see a spiral cork screw? this is driven by a connection at the back. Is the connection between the ice ...
...slide fingernail tip under the its free end. Repeatedly lift tab-end up slightly to bring it closer. Any tab lift gained is good. 4-use small piece of dry kitchen sponge to scrub , loosen an remove ...
...spiral) in the ice bucket? Dump the ice cubes and clean the ice storage bin. Is the ice dispenser stalling while dispensing ?crushed? ice? Change the ice button from ?crushed? to ?cubed.? If cubed ...
...spiral rod for manual declogging equipment. You can buy it at the hardware stores. OK, you did not specify if the leak is inside or outside of the unit, so i will address both issues here. OUTSIDE ...
...Slide out (drag out) the old fan from the base. Take out the spiral holder from the blde and Instal the blade in the motor and adjust the blade to right position. Reinstal the holder.My old blade was ...
...spiral rod (auger?) turns, but the blade in front of the plastic housing looks as if it might be missing a clip that holds the blade tight against the housing. I have inserted a screw partway into ...
33 questions posted
Usually answered in minutes!
822 Questions
518 Questions
315 Questions
239 Questions