Baby Lock Eclipse Serger "upper looper thread keep breaking" Questions

...thread in the recommended order or it will never serge properly: UPPER Looper first, LOWER Looper second with the thread tail Crossing Over the Upper Looper as the last step, then thread the

...looper thread is looped above the upper one(down where they all meet), it will break. Cut your lower looper thread and re thread it making sure its above the lower looper one. Lower your tension. ...

...upper looper? Remove all the threads from the machine. Clip them below the thread tree, RAISE the presser foot, and then pull all 4 threads down through the needle. (Never Pull Up!!) ALWAYS RAISE the ...

...upper looper thread keeps breaking I have used this serger with varying degrees of success for about 5 years. However, this latest problem appears to be unsolvable. After stitching about an inch, the ...

upper looper then lower looper then the needles if a thread breaks especially if it was one of the loopers, make sure to pull the needle thread out before hand then rethread. as for the breakages look

upper looper, lower looper, then needles. Follow (closely) the threading diagram on the machine. Missing one guide or hitting the guides out of order will throw you machine into a tizzy! On my serger,

...upper looper first then lower looper then needles also be sure needles are in with the flat back to the back of machine sequence of threading is imperative Check your owner's manual to see if you are ...

...Upper Looper, Lower Looper, then needles. Check the tension on that particular thread--too tight, it will break. Breaking thread after about an inch usually indicates it is mis-threaded--a guide has ...

upper looper thread keeps breaking have rethreaded and cleaned the machine try a new needles check for burrs make sure the thread is not caught anywhere Install a new needle. Remove the looper threads

...Which thread, needle threads, or looper threads? If looper threads, be sure to unthread both loopers and retread in correct order, 1;2;3;4: be sure upper looper is threaded before lower ...